Technical Data Table
Storage:
Temperature not to exceed 120° Fahrenheit or go below 25° Fahrenheit. In
cold temperatures membrane is to be stored in an area where the temperature is above 50°F. Protect products from inclement weather or excessive heat.
Sizes:
Standard Widths: 12", 16", 18", 24" and 36"
Standard Length: 50 lineal feet

Aquaflash Mastic:
A rubberized asphalt based adhesive to be used in conjunction with the Copper Aquaflash membrane to seal all horizontal terminations, seams, laps, protrusions and any accidental cuts or punctures. Temperature application is to be 25° F or above. No solvent based mastics are to be used without the approval of the manufacturer.

Aquaflash Emulsion Primer:
A solvent free, odorless primer specifically formulated to be used in conjunction with Copper Aqua Flash membmne to provide good initial adhesion and excellent permanent adhesion.
Uses:
Aquaflash Emulsion Primer is used to prime all surfaces where COPPER Aquaflash membrane is applied such as concrete, masonry and wood. The Aquaflash Emulsion Primer is to be used in ambient and substrate temperatures above 40°F (4°C). This primer can be applied to damp surfaces including green concrete.
Application:
Either spray, roll or brush apply Aquaflash Emulsion Primer at a rate of 250-300 square feet per gallon onto a clean, dry, dust and dirt free surface. Spread primer evenly, avoiding puddles. Allow primer to dry for 4 hours. On warm days drying may occur more rapidly. Any areas which are primed should be covered with Copper Aquaflash membrane within 24 hours or re-primed following the same procedure.
Storage:
Aquaflash Emulsion Primer may deteriorate upon freezing. Store in protected area. Do not apply below 40°F (4°C) or when rain is imminent.

Aquaflash Primer:
A one component solvent-base, high tack primer specifically designed to promote maximum adhesion of the Copper Aqua Flash membrane waterproofing on all vertical and horizontal surfaces where Copper Aquaflash membrane is to be applied.
Application:
Apply by spray, brush or long nap roller to all surfaces in an even coat at 250-300 square feet per gallon. At 75°F, allow primer to dry one hour minimum, 8 hours maximum. Primer has satisfactory cure when surface is tacky, but does not transfer when touched. If the Copper Aquaflash membrane is not applied within the maximum dry time, re-prime.
Do not apply below 25°F.
Packaging:
Aquaflash 500 solvent-base, high tack primer is packaged in 5 gallon pails. Caution:
Use with adequate ventilation and avoid breathing of vapors. In closed areas, workmen should wear approved breathing apparatus, protective clothing and eye protection. Avoid ingestion. See MSDS sheets for further information.

Products Information:
Safety and Handling Instructions:
Vapor emitted from the mastic are flammable and harmful. All Aquaflash materials should be handled in accordance with manufacturer's instructions. All users, prior to handling the Aquaflash products should read the Material Safety Data Sheets which are available upon request either from the distributor or our offices listed above.
Aquaflash Primer complies with VOC regulations.
No solvent based substitutions of mastic or primer are to be used in lieu of the Aqua Flash Primer.

Warranty:
All Aquaflash products are warranted to meet the specifications listed herein and are tested to assure conformance to the physical properties listed in the Technical Data Tables. Contact a Fiberweb representative for further information.

Page: 1 2